Starting the dig into the Ottawa Archives and The Great Lakes Museum in Kingston:

This project was started in 2015 but was delayed, firstly by my wife's death and then by COVID. Information on Woodstock has come primarily from the Archives in Ottawa and Kingston and although that is a 1000km trek from Port Stanley, it pales in comparison against the cost and time required to access British sources. This means that any attempt to create a highly accurate model of Woodstock at a specific time in history is doomed to failure. Since the model will go on display at the local Legion Branch 410 here in Ontario and where visitors may spend ten seconds looking at it, I have decided to model an approximate time period sometime after the North Africa campaign, late 1943. I am building a wood display box and have mounted it on the basement wall where the model is stored safely between construction efforts.

History is interesting because aside from the fact that it is written by the victors it is highly subjective. Whereas a textbook will be subjected to many reviewers and still get it wrong, the internet is full of stuff which has absolutely no verification whatsoever so relying on a single source, even if it is Wikipedia, will get you into trouble. In physics we have this drawing of being precise but wrong (I am 100% accurate that the cat is precisely dead/alive):

She changed over the years because of three major wartime refits. She was laid down in May '41 at Collingwood, ON, launched in December '41, and commissioned in May '42 in Montreal, QC. A minor refit was in September '42 acquiring lots of 20mm Oerlikons for Anti Aircraft work in the Mediterranean for the North Africa campaign, Operation Torch.

Much of the kit was modified and a new bridge made out of 10 thou' sheet styrene. The engine house was shortened and several other structures modified. When I build, I build sub-sub assemblies which are combined into sub-assemblies which are then combined onto the hull.

Fitting the parts together ...

Almost official portrait ...

Most Canadian corvettes carried an artistic endeavour on their forward 4-inch gun shield. There is not a lot of documentation on this and the best image I found was the one below and then from that I recreated my own. Donald of course, swatting a U-Boat with his cap ...

I built a wood display box and stained the wood with dark oak varnish stain.

Ready to be put up on the Legion Wall.
Most of the figures are from 3Djson at Etsy with a few additions from the original kit itself.